I rooted it and tried to install Xposed Modules which became yet another reason for it to fail. After numerous frustrating attempts, I got it to flash correctly. I opened it up and shorted 2 pins out to enter Maskrom mode to fix the issue. I have a Bluewave tablet which has a RK3288 processor which I bricked accidentally by flashing the wrong firmware. I checked the processor (in the (i) tab of the tablet), and it shows the following information: modelnumber: rk30sdk (this seems Rockchip to me.) Android: 4.1.A little bit of a back story of what I'm dealing with. There is quiet some time lag between my replies, but this is due to the fact that this is my son's tablet, and since I'm devorced, he (and his tablet) are not always at my place. Dear Markus, Thanx for all of your time, really appreciate it! Do you have any other suggestions that might help?īas & Merijn. Uploading the firmware when it is pink does not work here either. Then hitting 'switch' does turn it green (but it will not turn pink again when we hit the switch button again)). When we connect the tablet via USB and turn on USB data communication, followed by starting the batch tool, the tablet turns up pink. Dear Dexter, Thanx for your reply! We tried to use the 'switch' button, but if we start the connection with the PC by using the FFM button, and then hit 'switch', the batch tool replies with: '(layer4-2) this operation didn't do, because of not supporting!' Rockchip Firmware Download For Tabletsīest regards, Bas & Merijn. From this post we would like to present to you how to Flash stock ROM using Rockchip batch tool. Does anyone know what I can do to make it load the firmware?ĭownload Rockchip Batch Tool from here, run it on your Windows computer and flash stock Android firmware on your device with Rockchipset. I tried all sorts of things to prevent this from happening (switched off virus scanner, lowered security setting in my account), but nothing helped. On it), it and select the system.img file, it shows 'load firmware failed', as shown below. But now when I hit the button at the upper right corner (with. As far as I can judge, this is still 100% correct. The tablet shows up as a green square with 1-1-2 displayed under it. Next, when I open the RK batch tool (as administrator!), I connect the tablet while holding down the FFM button. So I downloaded the RK batch tool, downloaded the firmware from the Allfine website and installed the USB driver (the tablet is able to connect as a mass storing device to the computer). Some searching showed that it contains a Rockchip processor. We tried to update the firmware of an Allfine fine 10 joy tablet.
0 kommentar(er)
